Filter
Top Products
3 - 11
turns off and stops scanning after a good read. If you scan Do Not End
Character Activation After Good Read, the laser remains on after a good
read.
Default = End Character Activation After Good Read.
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the following bar
code, then setting the timeout (from 1-65535 milliseconds) by scanning dig-
its from the Programming Chart, then scanning Save.
Default = 5000 ms.
Character Deactivation Mode
If you have sent a character from the host to trigger the engine to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the fol-
lowing On bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to termi-
nate scanning.
Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart, page A-3, find the hex
value that represents the character you want to use to terminate scanning.
* End Character Activation After
Good Read
Do Not End Character Activation
After Good Read
Character Activation Laser
Timeout
* Off
On