Filter
Top Products
2 - 21
Timeout Retries
This setting limits the number of Communication Timeout retries. If the
Timeout Retries is set to 0, the transmission is terminated after the ini-
tial Communication Timeout. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
Programming Chart, then scanning Save. (5 is the recommended set-
ting.)
Default = 0.
Communication Timeout Beeper
This selection programs the engine to issue an error beep when a
communication timeout has occurred. The error beep sound is pro-
grammed using Number of Beeps – Error (page 3-4).
Default = On.
NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK
mode. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the Programming Chart, then scanning Save.
(5 is the recommended setting.)
Default = 0, or disabled.
Timeout Retries
O
f
f
* On
NAK Retries