Filter
Top Products
3 - 4
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The
same number of beeps will be applied to the beeper and LED in response
to a good read. For example, if you program this option to have five beeps,
there will be five beeps and five LED flashes in response to a good read.
The beeps and LED flashes are in sync with one another.
Note: The LEDs can also be programmed separately. See LED
Settings on page 3-5.
To change the number of beeps, scan the following bar code and then scan
a digit (1-9) bar code and the Save bar code on the Programming Chart
inside the back cover of this manual.
Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the engine for a bad
read or error can be programmed from 1 - 9. For example, if you program
this option to have five error beeps, there will be five error beeps and five
LED flashes in response to an error.
Note: The LEDs can also be programmed separately. See LED
Settings on page 3-5.
To change the number of error beeps, scan the following bar code and then
scan a digit (1-9) bar code and the Save bar code on the Programming
Chart inside the back cover of this manual.
Default = 1.
LED Indicators
The external LED can be programmed to be On or Off. Use the following bar
codes to program the external LED indicators.
Default = LED On with Good
Scan.
Note: The external LED refers to the signal Good Read LED and is not a
physical LED on the engine.
Number of Good Read Beeps/LED Flashes
Number of Error Beeps/LED Flashes