Filter
Top Products
3 - 13
Centering
Use Centering to narrow the engine’s field of view to make sure the engine
reads only those bar codes intended by the user. For instance, if multiple codes
are placed closely together, centering will insure that only the desired codes are
read.
Scan Centering On, then scan one of the following bar codes to change the left
or right of the centering window. To set the the percent you want to shift the
centering window scan the digits from the Programming Chart, then scanning
Save.
Default = 40% Left and 60% Right.
Note: Centering is dependent on the orientation of the engine. If the engine is
inverted, right becomes left and left becomes right.
Blinky Mode
Blinky Mode can be activated by Object Detection or the External Trigger.
When the Blinky Mode On or Blinky Always On/Continuous bar codes are
scanned, the scan engine blinks on and off at 50% duty cycle (250 milliseconds
on, then 250 milliseconds off.)
Default = Blinky Mode Off.
Centering On
* Centering Off
Left of Centering Window
Right of Centering Window
* Blinky Mode Off
Blinky Mode On
Blinky Always On/Continuous