Filter
Top Products
2 - 19
Character-Based Flow Control with Timeout: The engine asserts RTS
when it has a character to send and waits for a delay (see RS232 Timeout
on page 2-19) for CTS to be asserted by the host. If the delay time expires
and CTS is not asserted, the device transmit buffer is cleared and scanning
may resume.
Default =RTS/CTS Off, RTS Active.
RS232 Timeout
When using Flow Control with Timeout, you must program the length of the
delay you want to wait for CTS from the host. Set the length (in millisec-
onds) for a timeout by scanning the bar code below, then setting the time-
out (from 1-5100 milliseconds) by scanning digits from the Programming
Chart, then scanning Save.
Default = 1000 ms (1 second).
Flow Control, No Timeout
* RTS/CTS Off, RTS Active
Two-Direction Flow Control
Flow Control with Timeout
Character-Based Flow Control
with Timeout
Character-Based Flow Control,
No Timeout
RTS/CTS Off, RTS Inactive
RS232 Timeout