Filter
Top Products
3 - 7
the laser remains on after a good read, but the external trigger must be
pressed to scan the next bar code.
Default = End Manual Activation After
Good Read.
Manual Activation Laser Timeout -
External Trigger Settings
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when the external trigger is held down, and
after it is released. Set the length (in milliseconds) for a timeout by scan-
ning one of the following bar codes, then setting the timeout (from 1-65535
milliseconds) by scanning digits from the Programming Chart, then scan-
ning Save.
Default = External Trigger Hold 5000 ms, External Trigger
Release 0.
* End Manual Activation After
Good Read
Do Not End Manual Activation
After Good
Laser Timeout - External
Trigger Release
Laser Timeout - External
Trigger Hold