Filter
Top Products
4 - 6
Function Code Transmit
When this selection is enabled and function codes are contained within the
scanned data, the engine transmits the function code to the terminal. Charts of
these function codes are provided in Supported Interface Keys starting on
page 7-2. When the engine is in keyboard wedge mode, the scan code is con-
verted to a key code before it is transmitted.
Default = Enable.
Communication Check Character
To enhance security, you can specify the transmission type of a check charac-
ter; either LRC where the calculation starts on the first transmitted character,
LRC where the calculation starts on the second transmitted character, or CRC.
Note: This option adds a check character to the bar code data for all
symbologies. If you need to enable or disable check characters for
individual symbologies, see Symbologies beginning on page 6-1.
Scan the following bar code to set the communication check character type.
Default = None.
* Enable
Disable
* None
LRC Starts on 1st Character
LRC Starts on 2nd Character
CRC