Filter
Top Products
2 - 22
Support BEL/CAN in ACK/NAK
This protocol responds to <BEL> and <CAN> commands when in ACK/
NAK mode. The engine sounds an error tone when a <BEL> command is
sent from the host. <CAN> terminates the transmission.
Default = BEL/
CAN Off
.
RS232 Defaults
If you want the custom RS232 default settings restored to your engine,
scan the RS232 Defaults bar code below. This resets the engine to the
custom default settings (see Setting Custom Defaults on page 1-4). If
there are no custom defaults, it will reset the engine to the factory default
settings. Any settings that have not been specified through the custom
defaults will be restored to the factory default settings.
BEL/CAN On
* BEL/CAN Off
RS232 Defaults