Filter
Top Products
GROUND CONNECTION
The frame of the welder must be grounded. An earth
grounding lead must be connected to the grounding
terminal, marked on the input box floor with the symbol
(See
Figure A.2
). Refer to
Technical Specifi-
cations
page for proper ground wire size.
INPUT SUPPLY CONNECTIONS
Be sure the voltage, phase, and frequency of the input
power is the same as specified on the rating plate.
ELECTRIC SHOCK can kill.
• Have a qualified electrician
install and service this equip-
ment.
• Turn the input power off at the
fuse box before working on this
equipment.
• Do not touch electrically hot parts.
INSTALLATION
A-4 A-4
IDEALARC CV-400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
1
FIGURE A.1
RATING PLATE LOCATION
1. RATING PLATE
WARNING