Filter
Top Products
CONNECT WIRE FEEDERS
The wire feeder control cable can connect to the CV-
400 at the 14-pin amphenol on the front of the machine
(with the appropriate adapter cable) or the terminal
strips behind the hinged control panel cover. A strain
relief box connector is provided for cable access to the
terminal strips. The wire feeder grounding wire con-
nects to a chassis ground screw provided near the ter-
minal strips and marked with the ground symbol .
See the
Accessories
section of this manual for specif-
ic instructions for connecting the following automatic
and semiautomatic wire feeders to the CV-400:
Automatic Wire Feeders: NA-3, NA-5, NA-5R.
Semiautomatic Wire Feeders: LN-7, LN-7 GMA, LN-8,
LN-9, LN-9 GMA, LN-22, LN-23P, LN-25, LN-742.
INSTALLATION
A-8 A-8
IDEALARC CV-400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC