Filter
Top Products
INSTALLATION
A-5 A-5
PRO-CUT 25
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
NOTE: When using nitrogen gas from a cylinder, the
cylinder must have a pressure regulator.
• Maximum psi from a nitrogen gas cylinder to
the PRO-CUT 25 regulator should never
exceed 150 psi.
• Install a hose between the nitrogen gas
cylinder regulator and the PRO-CUT 25
gas inlet
.
CYLINDER could explode if dam-
aged.
• Keep cylinder upright and chained
to a fixed support.
• Keep cylinder away from areas where it could be
damaged.
• Never lift machine with cylinder attached.
• Never allow the cutting torch to touch the cylinder.
• Keep cylinder away from live electrical parts.
• Maximum inlet pressure 150 psi.
__________________
OUTPUT CONNECTIONS
Torch
The PRO-CUT 25 is sent from the factory with a 15’
PCT 20 cutting torch installed. Additional cutting torch-
es can be ordered from the K1615 series. Hand-held
torches come with 15' or 25’ cables.
WARNING