Filter
Top Products
TROUBLESHOOTING AND REPAIR
RETEST AFTER REPAIR
F-95 F-95
V350-PRO
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
Required Action
Expected Results
Rt. displayLft.display
Test
Steps
33
34
35
36
37
38
39
40
41
42
43
44
45
Adjust the remote output control potentiometer connect-
ed to the 6-pin amphenol connector to its highest set-
ting.
Adjust the remote output control potentiometer connect-
ed to the 6-pin amphenol connector to its lowest set-
ting.
This will only appear if a trigger switch is already con-
nected to the 6-pin amphenol connector on the front of
the machine and the trigger switch is presently on.
Turn the trigger switch connected to the 6-pin amphenol
connector off.
Turn the trigger switch connected to the 6-pin amphenol
connector on.
Turn the trigger switch connected to the 6-pin amphenol
connector off.
This will only appear if a potentiometer is still connect-
ed to the 6-pin amphenol connector. If this message
appears, disconnect the potentiometer from the 6-pin
amphenol connector.
This will only appear if a potentiometer is already con-
nected to the 14-pin amphenol connector. If this mes-
sage appears, disconnect the potentiometer from the
14-pin amphenol connector.
Connect a remote output control potentiometer to the
14-pin amphenol connector.
Adjust the remote output control potentiometer connect-
ed to the 14-pin amphenol connector to its highest set-
ting.
Adjust the remote output control potentiometer connect-
ed to the 14-pin amphenol connector to its lowest set-
ting.
This will only appear if a trigger switch is already con-
nected to the 14-pin amphenol connector and the trig-
ger switch is presently on. Turn the trigger switch con-
nected to the 14-pin amphenol connector off.
Turn the trigger switch connected to the 14-pin amphe-
nol connector on.
Turn the trigger switch connected to the 14-pin amphe-
nol connector off.
6-PIn roCP
6-PIn roCP
6-PIn rIgr
6-PIn Rigr
6-PIn rLgr
dcon
dcon
con
14-PIn roCP
14-PIn roCP
14-PIn rIgr
14-PIn rIgr
14-PIn rIgr
HI
Lo
oFF
on
oFF
6-PIn roCP
14-PIn roCP
14-PIn roCP
HI
Lo
oFF
on
oFF