Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPERATION
B-5 B-5
V350-PRO
7A. ADVANCED PROCESS PANEL
(See Figure B.2)
To program Welding modes. SELECT knob is used to
Scroll through all Welding modes. The MEMORY but-
ton is used to store and access Welding modes into
locations M1 thru M8.
Modes:
In addition to the 5 welding modes described in SEC-
TION 7, the Advanced Process Panel allows you to
select the Following additional modes.
• Power Mode
In the Power Mode;
The work point will be in the Volts window. The Amp
window will have CP displayed indicating Constant
Power. Once current starts flowing and during the 5
second “Hold” feature the displays will show Volts
and Amps respectively. Refer to the detailed expla-
nation at the end of this section.
• Gouge
Air Carbon Arc Cutting (CAC-A) is a physical means
of removing base metal or weld metal by using a car-
bon electrode, an electric arc and compressed air.
• Pulsed Modes
In Pulse Modes;
The work point will be in the Amps window and
should be set close to the wire feed speed of the
wire feeder in inches per minute. The Volts window
will have SPd displayed indicating Wire Feed
Speed. Once current starts flowing and during the 5
second “Hold” feature the displays will show amps
and volts.
Pulse Mode features that are displayed while select-
ing a Welding pulse mode are listed below;
Steel - .030, .035, .045, .052 – Argon Blends
Stainless Steel - .030, .035, .045 – Argon Blends &
Helium/Argon Blends
Aluminum - .035, 3/64, 1/16 – 4043 & 5356
Metal Core - .045, .052 – Argon Blends
Nickel - .035, .045 – Argon/Helium blends
Refer to the detailed explanation at the end of this
section.
MEMORY
MEMOR
MEMOR
Y BUTTON
(M1
(M1
THRU M8)
OUTPUT KNOB
SELECT BUTTON
ON
(HOT START OR ARC CONTROL)
ADJUST KNOB
ADJUST KNOB
(0 THRU 10-HOT START)
(-10 THRU 0 AND
0 THRU +10-ARC CONTROL)
SELECT KNOB
(SCOLLS WELDING PR
WELDING PR
OCESSES)
SELECT
ADJUST
SELECT
7A
REMO
REMO
TE
TE
ON
ON
REMO
REMO
TE
TE
LOCAL
LOCAL
WELD TERMINALS
OUTPUT
CONTROL
SELECT SELECT
MPS
A
OLTS
V
FIGURE B.2
ADVANCED PROCESS PANEL VERSION