Filter
Top Products
ACCESSORIES
C-14 C-14
COMPACT WIRE WELDERS
5. Cut off bent end of wire, leaving straight section.
6. Gently pull open the idle roll assembly to expose the
drive roll groove.
FIGURE C.8
FIGURE C.9
FIGURE C.10
4. Extend approximately 12 inches of wire from spool.
Straighten it out by back-bending it. Use care to
prevent the wire from dereeling.
2. Remove locking knob from spindle bolt by unscrew-
ing it.
3. Select wire alloy and diameter needed. Alloy 4043
and 0.035 wire size shown. Remove packaging and
data sheet from wire spool.
FIGURE C.5
FIGURE C.6
FIGURE C.7
LOADING ALUMINUM WIRE
1. Remove gas cone and contact tip. Remove spool
cover by unscrewing captive locking knob.
Alloy
Size
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC