Filter
Top Products
LINCOLN
ELECTRIC
5/16 Hex Head Screws
on Models with
Metal Handle
5/16 Hex Head
on Models with
Plastic Handle
3/4”
Screws
(2 Places)
2 Phillips Screws
FIGURE F.1 – CASE REMOVAL
CASE COVER REMOVAL AND REPLACEMENT PROCEDURE (CONTINUED)
PROCEDURE
1. Disconnect power to the machine.
2. Remove the two(2) 5/16 hex-head screws from the
top of the door and remove the door
3. Remove the ten(10) hex-head screws from the top
and left side of the machine. Note the position of the
two(2) longer screws. See Figure F.1
NOTE: If the machine has a plastic handle, remove the
5/16 hex-head screw from the front and remove
the handle.
4. Carefully lift and remove case cover from the
machine.
NOTE: Depending on what needs to be done, it may
be desirable to remove the handle on machines
with the metal handle. See Figure F.1
TROUBLESHOOTING & REPAIR
F-12 F-12
COMPACT WIRE WELDERS
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC