Filter
Top Products
C-16 C-16
COMPACT WIRE WELDERS
ACCESSORIES
CONNECTING THE GUN TO THE
WELDING MACHINE
1. Disconnect input power to the machine.
2. Make sure that the gun locking knob is loosened.
(See Figure C.20).
13. Reinstall spool cover. 1: tuck cover’s tab in place at
arrow and hold with thumb. 2: swing cover closed.
3: finger-tighten locking knob. 4: check for uniform
fit all around cover.
FIGURE C.17
FIGURE C.18
12. Cut off excess wire 1 to 2 inches from gas diffuser.
Install properly-sized contact tip slightly past hand-
tight. Install gas cone and hand-tighten.
1
2
3
4
FIGURE C.19
FIGURE C.20
3. Fully insert gun cable connection (welding power
and gas supply) into machine. Note that the master
Key way for P6 connector is located at the arrow.
4. Check that the cable connector’s end is flush with
insulator at A. Tighten gun locking knob (B) onto
cable connector.
P6
Connector
Key way
B
A
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC