Filter
Top Products
SAFETY PRECAUTIONS
• Have qualified personnel do all maintenance and
troubleshooting work.
• Turn the engine off before working inside the
machine.
• Remove guards only when necessary to perform
maintenance and replace them when the mainte-
nance requiring their removal is complete.
• If guards are missing from the machine, get replace-
ments from a Lincoln Distributor.
Read the Safety Precautions in the front of this manu-
al and in the Briggs & Stratton Owner’s Manual before
working on the WELDANPOWER 125.
Keep all equipment safety guards, covers, and devices
in position and in good repair. Keep your hands, hair,
clothing, and tools away from the recoil housing, fans,
and all other moving parts when starting, operating, or
repairing this machine.
ROUTINE AND PERIODIC
MAINTENANCE
ENGINE MAINTENANCE
To prevent the engine from accidentally starting, dis-
connect the spark plug lead before servicing the
engine.
See Table D.1 for a summary of maintenance intervals
for the items listed below. Follow either the hourly or
the calendar intervals, whichever come first. More fre-
quent service may be required, depending on your
specific application and operating conditions. Table
D.2 shows engine maintenance replacement parts and
numbers.
OIL: Check the oil level after every 5
hours of operation or daily. BE SURE
TO MAINTAIN THE OIL LEVEL.
Change the oil the first time after 5 hours of operation.
Then, under normal operating conditions, change the
oil after every 50 hours or once a year, whichever
occurs first. If the engine is operated under heavy load
or in high ambient temperatures, change the oil every
25 hours.
Drain the oil from the drain plug located on the engine
bottom, as shown in Figure D.1. Refill through the oil
fill until the oil reaches the FULL mark on the dipstick.
See Figure D.2. Use SAE 10W-30 grade oil.
FIGURE D.1 - OIL DRAIN AND
REFILL LOCATION
FIGURE D.2 - OIL CHECK PROCEDURE
FUEL: At the end of each day’s use, refill
the fuel tank to minimize moisture conden-
sation and dirt contamination in the fuel line.
MAINTENANCE
D-2 D-2
WELDANPOWER 125
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING
CAUTION
Do not screw in
dipstick to
check oil
Fill to FULL
mark on dipstick
- recheck
Tighten dipstick
firmly before
starting