Filter
Top Products
TROUBLESHOOTING & REPAIR
F-17 F-17
WELDANPOWER 125
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ROTOR RESISTANCE TEST (continued)
FIGURE F.3 – BRUSHES RETAINED WITH CABLE TIE
CABLE
TIE
BRUSHES
9. Reinstall the brush holder assembly after
the test. Depress the spring-loaded brush-
es into the holder and slip a suitable non-
metallic, fairly stiff retainer through the slots
at the top and bottom of the holder. A
cable tie works well; see Figure F.3. This
will hold the brushes up so that you can
easily install the holder.
10. Slip the holder into position in the genera-
tor end bracket. Be careful not to loosen
the 2 attached wires.
11. Reinstall and tighten the 2 screws with the
1/4” nut driver.
12. Slowly remove the non-metallic retainer
from the brush holder and let the brushes
snap back against the slip rings.
13. Snap the brush holder cover back into
position.