Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OUTPUT CHOKE REMOVAL AND REPLACEMENT (continued)
14. Reassembly: Install the output choke
assembly by setting it down into position.
Fit the idler solenoid plunger into the sole-
noid housing.
15. Assemble the quick connect splice that
connects lead #14 to lead #14A.
16. Connect the two leads #208 and #209 to
the idler solenoid.
17. With the 5/16" nut driver, install the sheet
metal grounding screw and the two green
ground wires.
18. With the 5/16" nut driver, install the one
sheet metal screw that holds the choke
assembly to the sheet metal.
19. With the 1/2" wrench, install the four
mounting screws that hold the output
choke in place.
NOTE: The two thread forming screws (with
shake-proof lock washers) are used in
the two holes nearest the engine.
20. With the 9/16" wrench, install the heavy
choke lead from the positive output termi-
nal.
21. Replace the output rectifier bridge. Refer
to "THE OUTPUT RECTIFIER BRIDGE
REMOVAL AND REPLACEMENT" proce-
dure in this section of the manual.
22. Replace any cable ties you cut for
removal. Fasten any cable restraints.
23. Replace the control panel and tighten the
6 sheet metal screws with the 5/16" nut
driver and 5/16" wrench.
24. Replace the top cover of the control box
and tighten the 8 sheet metal screws with
the 5/16" nut driver.
25. Start the gasoline engine and check the
low idle RPM. Low idle RPM should be
between 2250 - 2500 RPM. If adjustment
is necessary, refer to the topic "ENGINE
THROTTLE ADJUSTMENT TEST" in this
section of the manual.
TROUBLESHOOTING & REPAIR
F-52 F-52
WELDANPOWER 125