Filter
Top Products
ENGINE THROTTLE ADJUSTMENT TEST (continued)
FIGURE F.11 - BLOWER PADDLE MARKED FOR STROBE-TACH METHOD
Mark
TEST PROCEDURE
This test can be conducted by any of three
methods.
Strobe-tach Method:
1. Remove the spark plug wire to prevent
accidental kickback or starting.
2. With the black or red marking pencil, place
a mark on one of the blower paddles,
which can be reached through the vent
slots in the end bracket. See Figure F.11.
3. Connect the strobe-tach according the
manufacturer's instructions.
MOVING PARTS can injure.
Keep away from moving parts.
ENGINE EXHAUST can kill.
Use in open, well ventilated
areas or vent exhaust to the
outside.
4. Reconnect the spark plug wire and start
the engine. Direct the strobe-tach light on
the blower paddle and synchronize it to the
rotating mark.
TROUBLESHOOTING & REPAIR
F-27 F-27
WELDANPOWER 125
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING
WARNING