Filter
Top Products
35
INSTALLATION
SECTION 3-8
LUBRICATION
The machine is pre-lubricated except for the motor. For motor lubrication, check the tag supplied by
the motor manufacturer.
After the BP2400 Series Granulator has been in service for some time, the jackscrews and the main
bearings should be lubricated periodically.
Refer to Section 6, Maintenance, for further information.
TEST THE ZERO SPEED SENSOR {Continued from previous page)
Screen Cradle Jackscrew
Push the start button to start the granulator
When the machine reaches full speed, push the stop button to stop the granulator.
Open the screen cradle interlock using the procedure in Section 6-4 entitled Screen
Replacement.
Release the cradle retainers using the procedure in Section 6-9 entitled Screen Replacement.
While the rotor is still turning, actuate the screen cradle hydraulic cylinder or jackscrew
from the control console by turning the CC/screen cradle selector switch to the LOWER
POSITION.
The hydraulic cylinder or jackscrew should NOT operate until the rotor has come to a
complete stop.
If the hydraulic cylinder or jackscrew operates before the rotor stops, TURN OFF AND
LOCKOUT THE POWER per OSHA 1910.147 OR ANSI Z244.1-1982 (Lockout/Tag-out
of Energy Sources).