Sterling D48160s Saw User Manual


 
90
MAINTENANCE
SECTION 6-12
Cutting Chamber Access
When you REVERSE the jackscrew operating direction, always ALLOW THE JACKSCREW MOTOR
TO COME TO A COMPLETE STOP. Release the control switch and allow a minimum of 5 seconds
before switching to the opposite operating position. If you don't allow this pause, the JACKSCREW AND
OTHER COMPONENTS MAY BE SEVERELY DAMAGED.
LOWERING THE SCREEN CRADLE WITH JACKSCREWS
The jackscrews, which open the machine, should not operate until the rotor is completely stopped. If you
discover that the jack- screws DO operate while the rotor is still turning, immediately shut down the
machine and call for maintenance to adjust it.
Make sure no one is near the jackscrew or the cradle during operation.
Actuate the screen cradle jackscrew from the jackscrew console by turning the selector switch to
LOWER.
Hold the switch in position until the cradle stops. The jackscrew motor shuts down when it
reaches the end of its travel.
LOWERING THE SCREEN CRADLE WITH HYDRAULICS
You will need to access the screen cradle before initial startup and for various maintenance procedures. Before
accessing the screen cradle, make sure no one is near the hydraulic cylinders or hopper.
The hydraulic cylinders should not operate until the rotor is completely stopped. If the hydraulic system does
operate while the rotor is still turning, immediately shut down the machine and call for maintenance to diagnose
the system to find the fault.
Actuate the screen cradle hydraulic cylinders from the open/close control panel by turning the screen cradle
selector switch to the “LOWER” position. Hold the switch until the cradle stops at its fully open position, and
then release and return the switch to the off position.