89
RESTART THE GRANULATOR
If necessary to replace the fuses, call an electrician to do it.
UNLOCK AND TURN ON the main power.
Remove the OUT OF SERVICE tag.
Start the granulator by depressing the start pushbutton on the electrical cabinet.
MAINTENANCE
SECTION 6-11
Cutting Chamber Access
FASTEN THE CUTTING CHAMBER
Raise the hold-down clamps to their upright positions.
Turn the knobs clockwise until they are tight against the
chamber housing.
CLOSE THE CUTTING CHAMBER SAFETY
INTERLOCK
Engage the safety interlock by turning the actuator screw
clockwise with a box wrench or a ratchet wrench.
Make sure the screw is fully seated against the top surface
of its housing.
When engaged, the interlock closes the electrical control circuit to
the motor and allows the machine to run.