Filter
Top Products
88
CLOSE THE CUTTING CHAMBER WITH JACKSCREWS
MAINTENANCE
SECTION 6-11
Cutting Chamber Access
CLOSE THE CUTTING CHAMBER WITH HYDRAULICS
After completing any maintenance or adjustments inside the cutting chamber, use the following procedure to
close the cutting chamber and resume use of the granulator.
Make sure that no one is near the hydraulic cylinders or hopper, and clear the mating surfaces of the cutting
chamber of any debris that might prevent tight closure.
REMOVE THE ROTOR LOCATING PIN (if it is installed).
Actuate the cutting chamber hydraulic cylinder from the open/close control panel by turning the CC/Hopper
switch to the “LOWER” position. Hold the switch until the hopper stops, then release and return the switch to
the off position.
Make sure that no one is near the jackscrew or hopper.
Clear the mating surfaces of the cutting chamber of any debris
that might prevent tight closure.
REMOVE THE ROTOR LOCATING PIN if it is installed.
At the jackscrew console, turn the CC/Hopper (Cutting
Chamber/Hopper) switch to the LOWER position. Hold the
switch till the hopper stops.