Filter
Top Products
51
SETTINGS AND ADJUSTMENTS
SECTION 4-16
Adjusting or Replacing Rotor Knives
FASTEN THE CUTTING CHAMBE
R
Raise the hold-down clamps to their upright positions.
Turn the knobs clockwise until they are tight against the
chamber housing.
RESTART THE GRANULATOR
If necessary to replace the fuses, call an electrician to do it.
UNLOCK AND TURN ON the main power.
Remove the OUT OF SERVICE tag.
Start the granulator by depressing the start pushbutton on the electrical cabinet.
CLOSE THE CUTTING CHAMBER SAFETY
INTERLOCK
Engage the safety interlock by turning the actuator screw
clockwise with a box wrench or a ratchet wrench.
Make sure the screw is fully seated against the top surface of
its housing.
When engaged, the interlock closes the electrical control circuit to the
motor and allows the machine to run.