Sterling D48160s Saw User Manual


 
83
MAINTENANCE
SECTION 6-6
Screen Replacement
REMOVE THE SCREEN
The screen is divided into segments. Remove one
segment at-a-time.
Grasp it on its near edge and raise the edge by allowing
the screen to slide in the cradle.
Pull it toward you slowly allowing it to slide over the
edge of the screen cradle then, let it down onto the
machine support bar as you continue to pull it toward
you. Be careful not to hit the rotor knives with the
trailing end of the screen.
Ease it from the support bar to the floor and remove it
from the front of the granulator.
Repeat the foregoing steps for each segment of the
screen.
REPLACE THE SCREEN
Place the screen on the floor close to, and in front of the
machine. Set it on its circular surface with its long
dimension parallel with the machine.
Slide it along the floor until it touches against the support
bar underneath the machine.
Align one edge with the edge of the machine cradle.
Roll the screen toward you by pushing down on the near
side and then slide it up against the support bar.
Roll the backside of the screen up over the machine
support bar until its weight shifts to the support bar.
Work it back until it nestles between the support bar and
the cradle.
Push down on the near side until the screen slides around
with the front side low and the backside in a position that
will allow you to "roll" the screen up onto the screen
cradle.
(Continued on next page)