Filter
Top Products
Product Overview
16
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Soft Reset Switch
A soft reset switch provides a reset to the processor software on the PRP. You
access the soft reset switch through a small opening in the PRP faceplate. To
depress the switch, insert a paper clip or a similar object into the opening.
Caution The soft reset switch is not a mechanism for resetting the PRP and reloading the
IOS image. It is intended for software development use. To prevent system
problems or loss of data, use the soft reset switch only on the advice of Cisco
service personnel.
Flash Disk Slots
The PRP includes two Flash disk slots on the front panel of the card. Either slot
on the PRP-1 can support an ATA Flash disk or a linear Flash memory card. The
Flash disk slots on the PRP-2 can only support ATA Flash disks.
Note The PRP only supports +5 VDC Flash disk devices. It does not support +3.3 VDC
Flash disk devices.
All combinations of different Flash devices are supported by the PRP-1. You can
use ATA Flash disks, linear Flash memory cards, or a combination of the two.
Each Flash disk slot has an ejector button for ejecting a card from the slot. See the
“Using Flash Disks in the PRP” section on page 61 for more information.
Note Linear Flash memory cards may not have the capacity to meet the requirements
of your configuration. However, they can be used for emergency file recovery
applications.