Filter
Top Products
Checking the Installation
30
Performance Route Processor Installation and Configuration Guide
OL-11656-01
• b flash disk0: filename—Boots the file filename from the Flash disk in Flash
card slot 0
• b flash disk1: filename—Boots the file filename from the Flash disk in Flash
card slot 1
Caution The b flash disk0: and b flash disk1: commands are only used from the ROM
monitor (
Rommon>) prompt if the system fails to load normally. Do not use these
commands from the router (Router>) prompt.
While the system boots, the console screen displays a script and system banner
similar to the following:
Cisco Internetwork Operating System Software
IOS (tm) GS Software (PRP-P-MZ), Released Version 12.0(22)S
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 10-May-02 06:02a
Step 6 Observe the system startup banner. When you start up an unconfigured system for
the first time, the system automatically enters the setup facility, which determines
which interfaces are installed and prompts you for configuration information for
each one.
On the console screen, after the system displays the system banner and hardware
configuration, the following System Configuration Dialog prompt appears:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]:
Step 7 You can either proceed with the setup facility or exit from setup and use
configuration commands to configure global (system-wide) and interface-specific
parameters.
You do not have to configure the interfaces immediately; however, you cannot
enable the interfaces or connect them to any networks until they are configured.