Filter
Top Products
Additional Configuration and Maintenance Tasks
62
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Removing and Installing a Flash Disk in the PRP
The PRP has two Flash disk slots into which you can install ATA Flash disks,
linear Flash memory cards, or a combination of the two. Slot positions are labeled
slot 0 and slot 1.
The following generic procedure can be used for a Flash disk in either slot
position.
Removing a Flash Disk
To remove a Flash disk, follow these steps:
Step 1 Remove the Flash disk slot cover by loosening the captive screw shown in
Figure 15.
Step 2 To eject the card, press the ejector button until the card is free of the connector at
the back of the slot. (See Figure 16.)
Step 3 Remove the card from the slot and place it in an antistatic bag to protect it.
Step 4 Replace the Flash disk slot cover.
Table 13 Supported Flash Disk Sizes and Product Numbers
Flash Disk Size Product Number
64 MB MEM-12KRP-FD64=
128 MB MEM-12KRP-FD128=
255 MB MEM-12KRP-FD256=
1 GB MEM-12KRP-FD1G=