Filter
Top Products
Upgrading to the PRP
34
Performance Route Processor Installation and Configuration Guide
OL-11656-01
BOOTLDR =
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 4
Current Software state = STANDBY HOT
Uptime in current state = 2 hours, 13 minutes
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) GS Software (GSR-P-M), Version 12.0(26)S, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 25-Aug-03 10:44 by nmasa
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Step 2 Remove the Flash disk from the PRP card and install it into slot 1 of the active RP.
The following message will be displayed; do not format the disk.
22:21:31: %PCMCIAFS-5-DIBERR: PCMCIA disk 1 is formatted from a
different router or PC. A format in this router is required before an
image can be booted from this device
Note If your router is running an image prior to Cisco IOS Release 12.0(25)S2,
you are advised to insert the Flash disk into slot 1 of the standby RP, and
not the active RP.
Step 3 Verify the disk contents using the dir disk1: command (or the dir stby-disk1:
command if the Flash disk is in the standby RP).
Router# dir disk1:
Directory of disk1:/
1 -rw- 17329392 Dec 3 2003 11:44:46 +00:00
c12kprp-p-mz.120-27.S
63832064 bytes total (46465024 bytes free)