Filter
Top Products
71
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Additional Configuration and Maintenance Tasks
Step 9 Press Return.
After some interface information displays, the prompt appears as follows:
Router>
Step 10 Enter the enable command to enter enabled mode.
The prompt changes to the following:
Router#
Step 11 Enter the show start-up config EXEC command to display the enable password
in the configuration file.
Step 12 Enter the configure terminal command at the EXEC prompt.
You are prompted as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Change the configuration register value back to its original value (noted from
Step 3.)
Change it to a value of 0x0102 (factory default) using the config-register 0x value
command.
Step 13 Press Ctrl-Z or type end to exit configuration mode.
Step 14 Reboot the router and enable it using the recovered password.