Filter
Top Products
Upgrading to the PRP
42
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Step 18 Upgrade the Mbus-agent-rom by using the command upgrade mbus-agent-rom
all. Line cards do not need to be reloaded. If any error messages are displayed (see
following example), repeat this step before contacting Cisco TAC.
MBus agent ROM upgrade failed on slot 7 (rc=5)
MBus agent ROM upgrade failed on slot 8 (rc=6)
Step 19 Upgrade the fabric downloader by using the command upgrade
fabric-downloader all. The line cards do not need to be reloaded. If any error
messages are displayed (see following example), repeat this step before
contacting Cisco TAC.
Fabric-downloader upgrade failed on slot 7 (rc=5)
Fabric-downloader upgrade failed on slot 8 (rc=6)
Step 20 Make a note of which slot the PRP is installed in the chassis. You can use the show
gsr command to view this information. In the following example, the RP is
located in slot 3.
Router# show gsr
Slot 0 type = 3 Port Gigabit Ethernet
state = IOS RUN Line Card Enabled
Slot 3 type = Route Processor
state = ACTV RP IOS Running ACTIVE
Slot 17 type = Clock Scheduler Card(6) OC-192
state = Card Powered PRIMARY CLOCK
Slot 18 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 19 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 20 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 24 type = Alarm Module(6)
state = Card Powered
Slot 25 type = Alarm Module(6)
state = Card Powered
Slot 28 type = Blower Module(6)
state = Card Powered
Step 21 Use the command upgrade rom-monitor slot rp-slot.