Craftsman 315.220381 Saw User Manual


 
LEVELING THE FRONT TABLE
See Figure24.
Ifthere are any high or low areas on the fronttable,
they shouldbe removedby adjustingthe leveling
screwsin the center holes on the fronttable.
Place the rear table on its edge across thefront
table to check for gaps.
Adjustgaps of lessthan 1/32 in. in the center of
the table byturningthe setscrewwith a flat blade
screwdriveruntilthe setscrewtouchesthe frame.
Then lightlysecure the center pan head screw with
a phillipsscrewdriver.
For a gap of more than 1/32 in. in thecenter ofthe
table, raise the center byturningthe setscrew
against the frame. Then lightlysecure the center
pen head screw with a phillipsscrewdriver.
B For a gap ofmore than 1/32 in. on the sides,lower
the center of the table bytighteningthe center pan
head screwwith a phillipsscrewdriver.Then tighten
the setscrew.
PHILLIPSSCREWDRIVER
ONPANHEADSCREW
SETSCREW
REARTABLE
FRONTTABLE
Fig. 24
INSTALLING REAR TABLE, SPACER
TABLE, FENCE, AND CLAMPS
See Figures25A - 25C_
The placement ofthe tables and fence may need to
be changed for differentcuts, depending on the size
of theworkpiece and the positionof the blade. The
fence shouldbe installednextto the fronttable for
maximum depthcapacity; it shouldbe installedinthe
middle for maximum cross cutcapacity; and installed
all the way back for maximum ripcapacity.
B Locate the fence, the spacer table, the rear table,
and two unassembledclamps,whichconsistofthe
following hardware:
2 cup washers
2 clamp brackets
2 square nuts
2 thumbscrews
Place the fence behindthe fronttable,then the
spacer table behind it,and then the rear table
behind it,
Slipa square nut intothe slotofeach clamp
bracket.
B Place a thumbscrewintothe end of theclamp
bracketfarthest from the slot.Thread it intothe
square nut.
Note: Ifthe screwisinserted inthe wrongend ofthe
bracket,the clampwillnot work.
Placethe clamp bracketintothe rectangle holesin
the table support.Hold the cupwasher againstthe
rear table and turnthe thumbscrewclockwiseuntil
itsnaps intothe cup washer.
Tightenthe thumbscrews to clamp the tablesec-
tionsintoplace.
REARTABLE FENCE
SPACERTABLE FRONTTABLE
Fig. 25A
33 rRIIR'SMmN"RADIALSAW$1S,220,_1