Filter
Top Products
ACCESSORIES
C-2 C-2
V160-S & -T
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPTIONAL ACCESSORIES
AND COMPATIBLE EQUIPMENT
Factory Installed
Electrical Holder and Cable Assembly
Work Cable and Clamp
Strap Packet
Instruction Manual
Field Installed
K870 - Foot Amptrol
tm
for TIG welding. When the
V160-Sʼs Output Control is in the “REMOTE” position,
the foot Amptrol energizes the output and controls the
output remotely. The Foot Amptrol connects directly to
the 6 pin Amphenol.
K963-3 - Hand Amptrol
tm
for TIG welding. When the
V160-Sʼs Output Control is in the “Remote” position,
the hand Amptrol energizes the output and controls the
output remotely. The Hand Amptrol connects directly to
the 6 pin Amphenol.
PTA-17V TIG Torch -
150 Amp air-cooled compact and
durable Tig Torch with integral gas valve for gas control
at the torch. The following 1-piece cable torches can be
used with a K960-1 adapter:
• K1782-6 (12.50 Ft.) 1-Piece Cable
• K1782-8 (25.0 Ft.) 1-Piece Cable
PTA-9FV TIG Torch - Gas Valve flexible head torch:
• K1781-7 (25.0 Ft.) 1-Piece Cable
PTA-17FV TIG Torch - Gas Valve flexible head torch:
• K1782-11 (25.0 Ft.) 1-Piece Cable
K960-1-TIG Torch Adapter - for connection of PTA-
17V torches (1-piece cable) to power sources without
gas passing through the Twist Mate connection.
NOTE: Any remote control with trigger-only circuit,
such as the K814 Arc Start Switch, will not be sensed
by the V160-S remote control connection, and there-
fore will not allow control of the output.
CABLE PLUGS
K852-50 - Cable Plug Kit for #1-#2 cable. Attaches to
welding cable to provide quick disconnect from
machine.
TIG Torch Parts Kits - Parts kits are available for the
PTA-17 TIG torch. This kit includes back cap, collets,
collect bodies, nozzles and tungsten.
Order KP508 for PTA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel, alu-
minum and copper alloys. See publication C9.10.