Filter
Top Products
Four ScrewsFour Screws
FIGURE F.1 – CASE REAR SCREWS - REMOVAL
CASE COVER REMOVAL AND REPLACEMENT PROCEDURE (CONTINUED)
PROCEDURE
1. Remove input power to the V160S/T
2. Using a phillips head screwdriver, remove the
four screws on the back. See Figure F.1
3. Pull out the rear panel, take off the handle,
then remove the cover.
4. Perform the Input Filter Capacitor
Discharge Procedure detailed in this
section.
TROUBLESHOOTING & REPAIR
F-8 F-8
V160-S & -T
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC