Filter
Top Products
TROUBLESHOOTING & REPAIR
F-13 F-13
V160-S & -T
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
Check the
start resistor
(20 Ohms)
Check the
Fuse F1
C
heck
c
apacitors for
shorts
Check the input
bridge for shorts
or open
Input board checks
INPUT BOARD TEST
V160-S/T
(continued)
FIGURE F.4 – INPUT BOARD
TEST PROCEDURE
1. Locate test points. See figure F.4.
2. Check capacitors + input bridge for
open or shorts.
See input board schematic.
3. Check Fuse F1.
4. Check start resistor for 20 ohms.