Filter
Top Products
ACCESSORIES
CC-2 CC-2
V160-S & -T
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPTIONAL ACCESSORIES
AND COMPATIBLE EQUIPMENT
Factory Installed
1-Twist-Mate Torch Connector (W/Gas Pass Through)
1- Ground Lead and Plug Assembly
Strap Packet
Instruction Manual
Field Installed
K870 - Foot Amptrol
tm
for TIG welding. When the
V160-Tʼs Output Control is in the “REMOTE” position,
the foot Amptrol energizes the output and controls the
output remotely. The Foot Amptrol connects directly to
the 6 pin Amphenol.
K963-3 - Hand Amptrol
tm
for TIG welding. When the
V160-Tʼs Output Control is in the “Remote” position,
the hand Amptrol energizes the output and controls the
output remotely. The Hand Amptrol connects directly to
the 6 pin Amphenol.
K814 - Arc Start Switch - Energizes the output for TIG
welding if remote output control of the amperage is not
desired. It allows on/off TIG welding at the current set
by the Current Control on the control panel. When
using the Arc Start Switch set the Output Control to the
“LOCAL” position.
Magnum® PTA-9 and PTA-17 TIG Torches -
The fol-
lowing standard Magnum® TIG torches with one-piece
cable may be used with the Invertec V160-T.
• K1781-1 PTA-9 12.5 ft medium back cap
• K1781-3 PTA-9 25 ft medium back cap
• K1782-1 PTA-17 12.5 ft long back cap
• K1782-3 PTA-17 25 ft long back cap
NOTE: Each torch requires a Twist-Mate adapter,(one
is included with the machine). Collects, collect
bodies, and nozzles are not included and must
be ordered separately.
CABLE PLUGS
K852-50 - Cable Plug Kit for 1/0-2/0 cable. Attaches to
welding cable to provide quick disconnect from
machine.
Twist-Mate Torch Adapter K1622-1 - One is shipped
with the welder to connect the Magnum PTA-9 torch. If
you do not care to interchange this part between torch-
es
(one is required to connect Magnum PTA-9 or PTA-17
TIG torches with one-piece cable to the V160-T)
you
may order an additional adapters. The quick connect
plug provides connection for both gas and welding cur-
rent.
TIG Torch Parts Kits - Parts kits are available for the
PTA-9 and PTA-17 TIG torches. These kits include
back cap, collets, collect bodies, nozzles and tungsten.
Order KP507 for PTA-9 torches
Order KP508 for PTA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel, alu-
minum and copper alloys. See publication C9.10.