Filter
Top Products
11
1. INTRODUCTION
This addendum is based on the Model T100 Operators Manual (P/N 06807). In most ways the T100H analyzer
is identical to the T100 in design and operation, therefore most of the basic set up information,
operating instructions as well as calibration, maintenance, troubleshooting and repair methods are
found in that manual. This addendum documents only those areas where the T100H is different
in design or operating method from the T100.
1.1. T100H Documentation
NOTE
Throughout this addendum, words printed in capital, bold letters, such as SETUP or ENTR represent
messages as they appear on the analyzer’s front panel display
NOTE
The menu flowcharts in this addendum contain typical representations of the analyzer’s display during
the various operations being described. These representations are not intended to be exact and may
differ slightly from the actual display of your instrument.
1.2. Using This Manual Addendum
This manual addendum has the same overall structure as that of the T100 operator’s manual, to simplify
referring between the two. The manual has the following sections:
Table of Contents:
Outlines the contents of the addendum in the order the information is presented. This is a good overview of the
topics covered in the manual. There is also a list of tables, a list of figures and a list of appendices.
Specifications and Warranty
This section contains a list of the analyzer’s performance specifications, a description of the conditions and
configuration under which EPA equivalency was approved and Teledyne Instrument’s warranty statement.
Getting Started:
A concise set of instructions for setting up, installing and running your analyzer for the first time.
FAQ:
Answers to the most frequently asked questions about operating the analyzer.
Optional Hardware & Software
A description of optional equipment to add functionality to your analyzer.
07265A DCN6038