106 The NOAH 3 Module WinCHAP User’s Manual
Figure 8.2.1.1
8.2.1.2 To install the NOAH 3 Module from NOAH 3.
We recommend using the installation method specified in Section 8.3.1.1, but
you can also use the following method.
1. Open NOAH 3.
2. Open the Tools menu and point at Setup.
3. Select Install Module. This will bring up the Module Installation window.
4. Click
Install.
5. Open the NOAHModule directory in the WinCHAP directory. On most
computers, this will be: C:\Program Files\Frye Electronics\WinCHAP\
NOAHModule
6. Select install.ini and click
Open. This will install the WinCHAP NOAH
module.
8.2.2 Opening the WinCHAP NOAH Module
1. Select a client in the Client Register window.
2. Click
, the Open Module Selection button.
3. Select the
Measurement tab.
4. Select Frye Electronics. This will open the WinCHAP Module. See Figure
8.3.
8.2.3 Selecting the WinCHAP database and executable
When installing the NOAH module, it should automatically figure out where
the WinCHAP executable and database files are located. If for some reason this
doesn’t work, you can set these locations manually.
1. Open the Frye Tools
menu.
2. Point at
Settings and select Set WinCHAP Database
