10 Configuration WinCHAP User’s Manual
Figure 2.2.—Communications Setup Window
2.2.2 Designating the COM ports
To connect your FONIX analyzer or audiometer to your computer for use with
WinCHAP,
1. Select the COM port used by your FONIX analyzer or audiometer in the
appropriate drop-down list.
2. Click Check Analyzer
or Check Audiometer to verify your connection.
3. Click Save Settings
.
2.2.3 Adjusting the communication baud rate
Most FONIX equipment, such as the FONIX 6500-CX analyzer, FP40 analyzer,
and FA10/12 audiometer, have a fixed baud rate of 9600. You should not attempt
to adjust the communications baud rate for these instruments.
The FP35 and 7000 analyzers, however, have an adjustable baud rate. To adjust
it in WinCHAP, select the new baud rate with the Baud Rate selection in the
Communications Setup window. You will also have to make the same adjust
-
ment to the baud rate on your FP35 or 7000 analyzer. See your FP35 or 7000
Operator’s Manual for more information.
