Filter
Top Products
Call Processor Maintenance 55
Call Processor
Maintenance
This section provides maintenance tasks that are specific to just the call
processor.
Restarting the Call
Processor
To restart the Call Processor:
1 From the EMS explorer tree, navigate to the 3Com Sip Call Processor.
2 Right-click the Call Processor and select Maintenance and then click Hard
Restart.
Stopping the Call
Processor
To stop the Call Processor:
1 From the EMS explorer tree, navigate to the 3Com Sip Call Processor.
2 Right-click the Call Processor and select Maintenance and then click Hard
Shutdown.
Software status The current operational state of the entity. If
AdminStatus is down, then OperStatus should
be down. If AdminStatus is changed to up,
through the entity command interface, then
OperStatus should change to up if the entity
is operational; it should remain in the down
state if and only if there is a fault that
prevents it from going to the up state; it
should remain in the notPresent state if the
entity has missing components. If the entity is
operational, but not responding to queries,
the state is notResponding.
Read-only
Usage State Indicates how busy the resource is. Read-only
Table 25 Call Processor State Tab (continued)
Attribute Description Settings