Filter
Top Products
Table 1-2. HP 16532A Operating Characteristics (cont.)
MEASUREMENT AIDS
Time Markers:
Two vertical markers, X and O, are provided for measurements of time and
voltage. Capabilities are: measure voltage at point where X and O markers
cross each analog waveform; measure time from trigger to X, trigger to O, and
X to O; automatic marker placement by specifying percentage of edge, edge
number, and rising or falling edge type; run until X to O > than, < than, in
range, and not in range provides selective event search; X to O statistics (mean,
max, and min) provide analysis of time interval deviation.
Automatic Search:
Searches for a percentage or an absolute voltage level at a positive or negative
edge, count adjustable from 1 to 100.
Auto Search Statistics:
Mean, maximum, and minimum values for elapsed time from X to O markers for
multiple runs. Number of valid runs and total number of runs available.
Automatic Measurements:
The following pulse parameter measurements can be performed automatically:
Frequency Rise time + pulse width
Period Fall time − pulse width
V p-p Preshoot V
amplitude
*
Overshoot
(* gives difference between top and base
voltages; only available over bus)
Grid:
Graticules can be displayed in backround of waveform.
Voltage Markers:
Two horizontal markers, A and B, are provided for voltage measurements.
These markers can each be placed on any acquisition channel trace. A delta
voltage display provides delta V between markers on the same channel or
between two channels.
HP 16532A - General Information
1-7