Filter
Top Products
SECTION I
General Information
1-1. Introduction
The service policy for this instrument is replace-
ment of defective assemblies. This service guidel
contains information for finding a defective
assembly by testing and servicing the HP 16532A
1 GSa/s Oscilloscope Module. Also included in
the guide are installation procedures and a list of
recommended test equipment. This guide is
divided into six sections as follows:
I - General Information
II - Installation
III - Performance Tests
IV - Calibration
V- Replaceable Parts
VI - Service
The General Information Section includes safety
requirements, a product description, and a list of
accessories supplied and of accessories available.
Also included are tables listing specifications and
operating characteristics, and a list of
recommended test equipment.
To complete the service documentation for your
HP 16500 Logic Analysis System, place this
service manual in the 3-ring binder with your other
logic analysis system Service Guides.
1-2. Module Covered by This Manual
The information covered in this manual is for the
HP 16532A 1 GSa/s Oscilloscope Module.
1-3. Safety Requirements
Specific warnings, cautions, and instructions are
placed wherever applicable throughout the
manual. These must be observed during all
phases of operation, service, and repair of the
module. Failure to comply with them violates
safety standards of design, manufacture, and
intended use of this module.
Hewlett-Packard assumes no liability for the failure
of the customer to comply with these safety
requirements.
HP 16532A - General Information
1-1