Filter
Top Products
SECTION II
Installation
2-1. Introduction
This section explains how to initially inspect the
HP 16532A Oscilloscope Module, then how to
prepare it for use, storage, and shipment. Also
included are procedures for module installation.
2-2. Initial Inspection
Inspect the shipping container for damage. If the
shipping container or cushioning material is
damaged, it should be kept until the contents of
the shipment have been checked for
completeness and the module has been checked
mechanically and electrically. The contents of the
shipment should be as listed in the "Accessories
Supplied" paragraph located in Section I.
Procedures for checking electrical performance
are in Section III. If the contents of the container
are incomplete, there is mechanical damage or
defect, or the instrument does not pass the
performance tests, notify the nearest
Hewlett-Packard sales office.
If the shipping container is damaged, or the
cushioning material shows signs of stress, notify
the carrier as well as the Hewlett-Packard sales
office. Keep the shipping material so the carrier
can inspect it. The Hewlett-Packard office will
arrange for repair or replacement at
Hewlett-Packard’s option without waiting for claim
settlement.
2-3. Preparation for Use
Read the Safety Considerations in the front of
this manual and in Section I before installing
or operating this module.
2-4. Power Requirements
All power supplies required for operating the
HP 16532A Oscilloscope Module are supplied to
the module through the backplane connector in
the mainframe.
2-5. Safety Requirements
Specific warnings, cautions, and instructions are
placed wherever applicable throughout the
manual. These must be observed during all
phases of operation, service, and repair of the
module. Failure to comply with them violates
safety standards of design, manufacture, and
intended use of this module.
Hewlett-Packard assumes no liability for the failure
of the customer to comply with these safety
requirements.
2-6. Module Installation
Do not install, remove, or replace the module
in the instrument unless the instrument power
is turned off.
The HP 16532A Oscilloscope Module will take up
one slot in the card cage. For every additional
HP 16532A Oscilloscope Module you install, you
will need an additional slot. They may be installed
in any slot and in any order. The installation
procedure for the module is continued,
step-by-step, on the next page.
HP 16532A - Installation
2-1