Filter
Top Products
SECTION V
Replaceable Parts
5-1. Introduction
The service policy for this instrument is replace-
ment of defective assemblies. This service manual
contains information for finding a defective
assembly.
This section contains parts and ordering
information for the HP 16532A Oscilloscope
Module. Table 5-1 lists the reference designator
and abbreviations used throughout this manual.
Table 5-2 lists all replaceable parts by reference
designator.
5-2. Abbreviations
Table 5-1 lists abbreviations used throughout the
manual. In some cases two forms of the
abbreviations are used, one in all capital letters,
the other partially or not capitalized. This was
done because the abbreviations in the parts list are
always all capitals. However, in other parts of the
manual other abbreviation forms are used with
both lower and uppercase letters.
5-3. Replaceable Parts List
Table 5-2 lists replaceable parts and is organized
as follows:
• Exchange assemblies in alphanumerical
order by reference designation.
• Electrical assemblies in alphanumerical order
by reference designation.
• Chassis-mounted parts in alphanumerical
order by reference designation.
The information given for each part consists of the
following:
• Complete reference designation.
• Hewlett-Packard part number.
• Total quantity.
• Description of part.
• Check digit.
The total quantity for each part is only given once
at the first appearance of the part number in the list.
5-4. Ordering Information
To order a part listed in the replaceable parts table,
quote the Hewlett-Packard part number, check
digit, indicate the quantity required, and address
the order to the nearest Hewlett-Packard office.
To order a part that is not listed in the replaceable
parts table, include the instrument model number,
instrument serial number, the description and
function of the part, and number of parts required.
Address the order to the nearest Hewlett-Packard
office.
5-5. Exchange Assemblies
Exchange assemblies are available when a
repairable assembly is returned to
Hewlett-Packard. These assemblies have been set
up on the "Exchange Assembly" program. This
allows the customer to exchange the faulty
assembly with one that has been repaired,
calibrated, and performance verified by the
factory. The cost is significantly less than that of a
new assembly.
HP 16532A - Replaceable Parts
5-1