Filter
Top Products
Module Installation (cont.)
The effects of ELECTROSTATIC DISCHARGE can damage electronic compo-
nents. Use grounded wrist straps and mats when you are performing any kind of
service to this module.
Installation Considerations
• The HP 16532A Oscilloscope Modules can be installed in any available card slot.
• For multiple modules connected as one unit, the master card must be placed in the slot above the
expander cards. The master card and expander cards must be in adjoining slots.
• Cards or filler panels below the empty slots intended for module installation do not have to be re-
moved to install a module above them.
Procedure:
1. Turn instrument power switch off, unplug power cord and disconnect any input connections.
2. Starting from the top, loosen the thumb screws on the filler panels and cards.
3. Starting from the top, begin pulling out the cards and filler panels halfway. See figure 2-1.
Figure 2-1. Endplate Overlap - Top Sequence
HP 16532A - Installation
2-2