Filter
Top Products
26
206-4271
Express Script (Cont.)
Complete the TV Conguration
The following procedure describes the remaining steps in the Express Script. You can select the
“BACK” button, where available, to check previous settings, as necessary.
Note: If you choose to exit the Express Script from this point on, any settings made
will not be retained.
Note: Typically, if you do not modify the default settings, the “NEXT” button is automatically
selected when you proceed forward within the Express Script. Where appropriate, you can simply
press OK on the Installer Remote to proceed to the next step if the default value(s) for the TV
parameter(s) in question are applicable for your installation.
1. In the Select the Tuning Band screen, use the Up/Down arrow keys on the Installer Remote to
highlight/select the appropriate tuning band option: Cable Standard (default), Cable HRC, Cable
IRC, or Air. Then, press OK. When you have made your selection, use the arrow keys to select
NEXT, and then press OK.
SELECT THE TUNING BAND
BACK
NEXT
Select the tuning band you would like to use:
Cable Standard
Cable HRC
Cable IRC
Air
02
EXIT
2. By default, all Aux inputs are enabled, as shown initially in the Enable/Disable Aux Inputs
screen. To disable an Aux input, use the arrow keys on the Installer Remote to select the desired
input, and then use the Left/Right arrow keys to toggle the status value to DISABLED.
ENABLE/DISABLE AUX INPUTS
BACK
NEXT
Enable/disable Aux inputs as required.
AV IN/Audio IN (DVI)
<
ENABLED
>
HDMI 1
<
ENABLED
>
HDMI 2
<
ENABLED
>
03
EXIT
(Continued on next page)