Filter
Top Products
68
206-4271
IP Environment Setup (Cont.)
Conguring a Wired Network Connection
Note: If desired, you can congure both wired and wireless
connections. However, note that a wired connection is always
prioritized over a wireless connection. That is, when the TV is
turned OFF and then back ON, if a LAN cable is detected between
the TV and the network, the TV will default to the wired connection.
If the LAN cable is removed, the TV will then attempt to establish
the wireless connection. Whenever the LAN cable is reconnected,
the TV will re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press OK. A
second Network screen (see example at right), with Wired and
Wi-Fi Connection setup options, will be displayed.
By default, the TV uses DHCP, and if a LAN cable is detected,
the TV will attempt to connect to the network as soon as you
select “Network Setting” above. If the TV is able to connect to
the network, a “Connected to Internet” message will be displayed
below the Wired Connection eld.
3. If the network is not congured for DHCP or you want to specify
static conguration data or you would like to change the network
conguration from Manual to Automatic, edit the IP conguration
for this TV as follows:
• In the second Network screen, select Wired Connection and
press OK. Then, in the Wired screen, select Edit (if not already
selected) and press OK.
• In the Edit IP screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
conguration is enabled.
• To manually edit the IP conguration, for each data entry
eld: Use the arrow keys on the Installer Remote to select
the eld and press OK. You can use the number keys on the
Installer Remote to direct enter numeric values or use the
arrow keys to select the appropriate numbers from the pop-up
virtual keyboard displayed at the bottom of the screen. (Note,
however, that you must use the dot “.” key from the virtual
keyboard to separate each octet of an IP address.) When you
are done, select Enter from the virtual keyboard, and then
press OK on the Installer Remote.
• When all Edit IP elds are set as required, use the arrow keys
on the Installer Remote to select Connect and press OK.
At the top of the screen, you will see a progress display that
indicates status as each network element is conrmed (see
example at right).
(Continued on next page)
NETWORK
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
Pro:Centric
Network
Pre-loaded Apps
EDIT IP
Connected to Internet
Set Automatically
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
DNS
CONNECT
Pro:Centric
Network
Pre-loaded Apps
WIRED
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address AA:45:F7:52:F8:0F
DNS
EDIT
Pro:Centric
Network
Pre-loaded Apps