Filter
Top Products
58
206-4271
Cloning Procedures (Cont.)
(Continued from previous page)
• If the TLX le includes an FTG Channel Map with RF channels and Aux inputs only, you can
choose the format for the channel tuning/banner display. Use the arrows keys to select the
desired Channel Tuning / Channel Banner Display option—either Logical or Physical—at the
right side of the Teach to TV (TLX) screen. A checkmark will appear at the left of the selected
option. Logical tuning is selected by default.
Note: If an FTG Channel Map includes IP channels, only logical tuning is available. Also, if a
TLX le does not include an FTG Channel Map, the message, “No Channel Map in TLX le,”
will be displayed at the right of the screen.
9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then
press OK on the Installer Remote.
CANCEL
BACK
UPDATE
Channel Tuning / Channel Banner Display
Logical
Physical
TEACH TO TV (TLX)
TV MANAGER
Select USB Memory Device
ˇ
USB Device 1:
Device Name
Select the file to download, and then select UPDATE below.
xxLY770M-UA00001.TLX
Teaching status will be shown in a pop-up progress banner at the bottom of the Teach To TV
(TLX) screen. This process may take a few minutes. Do NOT remove the USB device until
Teaching is complete. When the Teaching process is complete, an “Updating completed”
message is briey displayed, and the TV exits the TV Manager / USB Download Menu.
10. Remove the USB memory device from the Target TV, and verify that the appropriate
conguration is now resident on the Target TV.
Note: If the Target TV was previously in Pass-through Mode, and the TLX le used for Teaching
contained an FTG Channel Map, the Target TV CPU is now in FTG Mode via CPU. After the
Teaching process is complete, the TV tunes according to the Start Channel setting in the Installer
Menu. If a Start Channel is specied, the TV will tune to that channel, though, in the case of
FTG Mode via CPU conguration, a channel banner will only be displayed if the Start Channel is
included in the FTG Channel Map (depending on your selection in step 8, the channel banner will
display either the Start Channel’s logical channel number or physical RF channel number).
Otherwise, the TV will either return to the last channel tuned (TV in Pass-through Mode) or tune to
the rst channel in the FTG Channel Map (TV in FTG Mode via CPU). If the latter, remember that
the channels in the FTG Channel Map are always arranged in logical order, regardless of your
selection in step 8.