Filter
Top Products
PROCEDURE
1. Remove input power to the POWER WAVE
355/405.
2. Using a 5/16” nut driver remove the case wrap-
around cover.
3. Perform the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
4. Using a 5/16” nut driver remove the four screws
from the bottom and right side of the rear assem-
bly. See Figure F.34.
TROUBLESHOOTING & REPAIR
CURRENT TRANSDUCER REMOVAL AND REPLACEMENT (continued)
F-74 F-74
POWER WAVE 355/405
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OFF
OFF
OFF
OFF
OFF
OFF
Plastic
Nut
5/16" Mounting Screws
REAR
FIGURE F.34 – CASE BACK SCREW LOCATIONS